Repeatedly press the key until you return to the main screen. The key fob will be enrolled with the system.Ĥ. Once the zone you want to use is displayed, press the key to continue. In most cases, this zone will work fine, but you can also use the arrow keys on the system to select a different key zone. The WS4949 will be assigned to the next available key fob zone by default. When all digits have been viewed, the panel will exit the section. Press any of the Emergency Keys to advance to the next digit. Confirm that it is correct, and press the key to continue.ģ. while panel is waiting for 3-digit section (Armed light is ON) Simply read the information displayed on the screen.
#Dsc dls programming keyfob serial number#
When it does, the serial number for the key fob will be displayed on the screen.
It will take about three seconds for the system to recognize the device. Press and hold either button on the WS4949. If the command was entered correctly, the screen will display "Wireless Enrollment Mode".Ģ.
#Dsc dls programming keyfob code#
The default Installer Code for the system is 5555. Start with the DSC Impassa, and make sure the system is powered on and disarmed. Additionally, if both buttons are pressed and held down, a system panic will be triggered.Ĭomplete the following steps to program a DSC WS4949 with a DSC Impassa:ġ. The key fob has two buttons - one for arming, and another for disarming. It can work with the Impassa because it operates at the compatible wireless frequency of 433 MHz. The WS4949 is a 2-button key fob that is designed for use with DSC Alarm Systems. If done successfully the key fob should be recognized and learned in with the system. You can program a DSC WS4949 Key Fob to a DSC Impassa by putting the system into its wireless enrollment mode and then pressing and holding a button on the DSC WS4949 Key Fob for at least three seconds.
0 kommentar(er)
